I-MATE SP3 PDA Batteries usage tips:

1. Please check your original I-MATE SP3 Battery part number & model number with our postings picture before the purchase to make sure you get the correct battery for I-MATE SP3. Replacement Battery I-MATE SP3 are brand new with new case and new cells, we have 1 year replacement warranty on these I-MATE SP3 PDA Batteries.
2. New I-MATE Replacement battery SP3 usually comes in a discharged condition and with a very low capacity. It is generally recommended to fully charge new battery packs before use. The I-MATE SP3 battery pack needs to be circulated (fully discharged and recharged) 3 - 5 times to reach its optimum performance.
3. Rechargeable battery I-MATE SP3 will undergo self-discharging when left unused. It should always be stored in a fully charged status and kept in a cool, dry and clean place. To maintain the optimum performance of I-MATE SP3 battery pack, it is highly recommended to fully discharge and recharge it at least once a month.
4. It is normal if a battery gets warm when being charged or used. However, please pay high attention when the battery pack becomes excessively hot. This may indicate a problem with the charging circuit of your electronic device. It is necessary to have it checked by qualified technicians when this occurs.
5. Sometimes,I-MATE SP3 PDA Batteries is hard to be charged. Your electronic device may indicate a fully charged condition for about 10 to 15 minutes when a new battery pack is being charged for the first time. When this happens, remove the battery pack and let it cool down for awhile. Repeat the charging procedure again. When a new I-MATE SP3 battery is unable to charge, it is suggested to remove the battery from the device and reinsert it for several times to wake up dormant cells. Occasionally, BIOS updating is required to make the battery work normally on your device.